A technician in plain workwear winding a new torsion spring above a closed garage door with winding bars in a tidy garage

Spring repair · Newark, NJ

Garage Door Spring Repair in Newark

A snapped torsion or extension spring leaves a heavy door stuck shut. We come to you, replace the spring safely, and explain what we found and the price before any work starts.

  • Licensed and insured
  • Upfront quote before work
  • Parts-and-labor warranty

What the job involves

Why garage door spring repair is a job for a technician

A broken garage door spring usually announces itself with a loud bang from the garage, then a door that will not lift. The spring is what carries the door's weight. Without it, a typical double door asks the opener or your arms to lift more than a hundred pounds, which is why a snapped spring leaves the door stuck and the opener groaning.

There are two kinds. Torsion springs are mounted on a bar above the opening and are the common choice on newer doors. Extension springs run along the sides of the horizontal track and often pair with safety cables. Every spring is built for a set number of open-and-close cycles, so a spring on a door used several times a day wears out sooner than one on a seldom-used door. Cold North Jersey winters stiffen lubricant and make the metal less forgiving, which is one reason springs often break on the first cold mornings. A door that will not lift can also be a cable problem, which is why we check both. If the door itself is worn out, a new door is worth pricing next to the spring repair.

A technician in plain workwear inspecting a snapped torsion spring with a visible gap in the coil above a garage door

Our diagnosis

What we check before replacing a spring

Which spring type you have

Torsion or extension, and whether it is a single or a pair. The type decides the method and the parts.

Door weight and size

A spring must match the weight of the door. We weigh up the door, the panel material and any windows or insulation before choosing wire size and length.

The second spring

Two springs usually wear at the same rate. If one has gone, the other is close behind, and we tell you what we see so you can decide.

Cables, drums and bearings

Lift cables fray and drums crack. A fresh spring on worn cables just moves the failure, so we look at the full lift system.

Rollers, hinges and tracks

Worn rollers and bent tracks put extra strain on a new spring. We note anything that will shorten its life.

Balance after the repair

A correctly set spring holds the door at about waist height with the opener disconnected. We test this before we leave.

How it works

How a spring replacement goes

  1. 01

    You tell us what happened

    Say what you heard and what the door is doing now. Leave the door where it is and do not try to force it.

  2. 02

    We come out and check it

    A uniformed technician examines the springs, cables, drums and tracks, and confirms the spring is the problem.

  3. 03

    We explain what we found and the price

    You get an upfront quote before any work begins, and the technician explains the problem before starting.

  4. 04

    We replace the spring and test the door

    We fit and wind the new spring, adjust the tension, lubricate the moving parts and test the door's balance. A spring swap is normally done in a single visit.

Heard a bang and now the door won't budge?

Leave it down, keep clear of it, and tell us what you're seeing.

Our work

Spring replacements, finished and balanced

A fresh pair of torsion springs mounted on a clean shaft above a closed garage door, with the center bracket and cable drums visible
New torsion springs on the shaft
A close-up of the winding cone, winding bar and set screws on a torsion spring during adjustment
Winding the spring to tension
A technician lightly holding a garage door that stays steady halfway open with the opener disconnected, checking its balance
Testing the balance

Questions

Spring repair questions

Can I repair a garage door spring myself?
We advise against it. A wound spring stores enough energy to cause serious injury, and the winding bars and correct tension are not tools most homeowners have. Replacing the spring is a technician's job.
How common is it for a garage door spring to break?
Every spring breaks eventually, because each is built for a limited number of cycles. A spring on a door used daily wears out sooner than one on a door used rarely, and a broken one is among the most common reasons a door stops lifting.
How much does it cost to replace a garage door spring?
It depends on the spring type, the wire size matched to the door weight, whether you replace one spring or a pair, and any cables or drums that need work. We give you an upfront quote before any work begins and explain each part in plain words.
Is replacing a garage door spring hard?
It is not complicated for a trained technician, but it is dangerous without the right tools. Getting the tension right is what separates a door that balances from one that slams or will not stay open.
Is it safe to use the door with a broken spring?
No. Leave it closed if you can, and do not try to open it by hand or with the opener. If the door is open, keep people and cars from under it until it has been checked.
How do I know it is the spring and not the opener?
A bang before the door stopped moving, a visible gap in the coil, or a door that feels very heavy with the opener disconnected all point to the spring. An opener that hums or clicks but does not lift is often reacting to a broken spring.
Is the repair covered?
Yes. Repairs and installations are backed by a parts-and-labor warranty, and we are licensed and insured. We go through what that covers when we explain the work.

Spring repair · Newark, NJ

Spring snapped and the door won't open?

Leave the door down and tell us what happened. We'll come out, check the spring and cables, and explain the fix before any work starts. Locally owned and operated, with uniformed technicians.